|
A.) |
Wire mesh partition
shall be Standard Wire & Works type No. 135 size group S.
|
|
B.) |
10 gauge (.135) steel
wire, woven into 1 1/2" diamond mesh, with wire securely clinched to
framing.
|
|
C.) |
Wire shall be woven
through a horizontal 1" x 1/2" x 12 Ga. channel bar at 3' - 6 1/8" from
bottom of partition.
|
|
D.) |
Vertical frames 1
1/4" x 5/8" "C" type, cold rolled channel. Horizontal frames 1" x 1/2" x
12 Ga. channel mortised and tenoned at intersections.
|
|
E.) |
Top capping bar 2
1/2" x 3/4" cold rolled channel with 1/4" "U" bolts approximately 14"
O.C.
|
|
F.) |
Corner post 1 1/4" x
1 1/4" x 1/8" angle.
|
|
G.) |
Cast iron floor shoes
1 1/2" high with set screw adjustment.
|
|
H.) |
Door Frames 1 1/4" x
1/2" x 12 Ga. channel with 1 1/4" x 1/8" cover plate on four sides.
|
|
I.) |
Sliding doors to
have: Two, 4-wheel ballbearing trucks hung in enclosed box track hung in
enclosed box track; cast iron door strike keeper; bottom guide channel.
|
|
J.) |
Hinged doors to have:
1 1/2 pair fast pin butts: continuous 1 3/8" x 7/8" x 1/8" angle
strike.
|
|
K.) |
3" sweep space under
all panels and doors.
|
|
L.) |
Aluminum cylinder
mortise type locks with cylinders individually keyed,
keyed alike, or master keyed to the building systems. All locks to have
recessed knob on inside (bronze cylinder mortise type locks can be
special ordered).
|
|
M.) |
All hardware
necessary for proper installation to be furnished.
|
|
N.) |
Finish: one shop coat
steel gray gloss enamel (or specify other color if desired).
|
